Jm Roll Tarp GRAIN CARTS (June 2011 & newer) User Manual

J. & M. MFG. Co., Inc.P.O. Box 547 Ft. Recovery, OH 45846PH: (419) 375-2708www.jm-inc.comRevision 7/24/2012

10Install Cable ClampsCable Clamp AssemblyUsing the three cable clamp, feed one end of the cable through the cable clamp, make a small loop then tight

11Install the Spring ReturnInstall Tarp StandosInstall the plastic stand-os. Place the stando approximately 3 inches from the top of the sideboard

12Install Stop TubeInsert Roll Tarp TubesPrepare the canvas tarp. Spread the canvas tarp our so that the 3 stiening patches are on the opposite auger

13Install Pop Rivets on Roll TubeInstall the Roll Tarp StopsLine the roll tube spool up with the spring return cable. Drill a 1/4” hole through the r

14MANUAL HEADERMANUAL HEADERAttach the knuckle to the roll pipe. Use (2) 3/8” x 2” hex bolts along with (2) 3/8” lock nuts. Now attach the crank hattn

15

16PARTS LIST525 620 750 875 1000 1050Tarp Crank Handle S L L L XL XLSquare Tubing (1" x 1" Sq. Tube) 14 Gauge144" 158" 168" 1

17PARTS LIST1130 Leaner 1150 1250 Leaner 1325/1400 1500 LeanerTarp Crank Handle XL XL XL XL XLSquare Tubing (1" x 1" Sq. Tube) 14 Gauge264&q

2ORDER OF OPERATIONS1. Assemble the Rear Endcap on the oor.2. Assemble the Front Endcap on the oor.3. Install the Hanger Bracket.4. Place the Lip Lo

3FRONT ENDCAP ASSEMBLY REAR ENDCAP ASSEMBLYAssemble the Rear Endcap on the ground. Attach the Rear Endplate to the Rear Endcap using 1/4” x 1/

4Hanger Bracket (International Series)Install the roll tarp hanger bracket. Use (4) M10-1.5 X 25 Gr8.8 YZ SF Hex Bolts and (4) M10-1.5 Gr8.8 YZ SF H

5Tightening LipHanger Bracket Hardware (Standard U.S.Series)Install the roll tarp hanger bracket. Use (4) 3/8”-16 X 1” Gr5 Z SF Hex Bolts and (4) 3/

6Install the Rear EndcapPlace the Rear Endcap Assembly onto the back of the grain cart. Slide the endcap to the right until it makes contact with the

7Rear Endcap Support BraceInstall the Endcap Brace. e purpose of the endcap brace is to hold the inside of the endcap up approximatley 1” higher than

8Tighten Rear EndcapInstall J-BoltsPull the Tightening Lip tight against the opposite auger side of the grain cart. Using a 1/4” bit, drill through th

9Tarp BowsInstall the Front Endcap Install the front endcap assembly using the same procedure used to install the rear endcap assembly. e front endca