Pg. 1 O P E R A T O R ’ S M A N U A L Set-Up Instructions and Parts Catalog for Model HT-974 Low Profile Header Transports
Pg. 10 5. Attaching the Adjustable Header Mounts and Tie-Down Brackets Place the Adjustable Header Mounts and Tie-Down Bracket Assemblies on t
Pg. 11 PARTS LIST Main Frame and Upper Bar Tongue Assembly # Part # Description # Part # Description 1 IT-HT8NS Inner
Pg. 12 Front and Rear Axle Assembly # Part # Description # Part # Description 1 FA-974 Front Axle Only, Less Hub and Spindle A
Pg. 13 PARTS LIST Tie-Down Bracket and Adjustable Header Mount Adjustable Upper Bar Mount # Part # Description 1 UBCM-3 Upp
Pg. 14 PARTS LIST Light Kit # Part # Description # Part # Description 1 EB-1 Extension Bracket 14 141-CB 1/4" x 1" Bolt 2 AI
Pg. 15 INITIAL OPERATION / MAINTENANCE BE CERTAIN THAT ALL POWER IS SHUT OFF BEFORE SERVICING THE HEADER TRANSPORT Before the header transport is put
Pg. 16 SERVICE / MAINTENANCE RECORD Date Description Notes
Pg. 2 TO THE DEALER: Read manual instructions and safety rules. Make sure all items on the Dealer’s Pre-Delivery and Delivery Check Lists in the Ope
Pg. 3 MODEL HT-974 Header Transport Specifications DIMENSIONS HT-974 HT-974XL HT-974XL-36 A 12’-0” 15’-0” 17’-0
Pg. 4 GENERAL INFORMATION TO THE OWNER: The purpose of this manual is to assist you in operating and maintaining your running gear in a safe manner.
Pg. 5 GENERAL INFORMATION (continued) BOLT TORQUE CHART Always tighten hardware to these values unless a different torque or tightening procedure is
Pg. 6 TABLE OF CONTENTS INTRODUCTION 2 EXPRESS WARRANTY 2 SPECIFICATIONS 3 GENERAL INFORMATION 4 BOLT TORQUE CHART 5 SAFETY RULES 7 SAFETY 7 SAFETY S
Pg. 7 SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Safety is a primary concern in the design and manufacture of our products.
Pg. 8 DW-108 DW-121 FRONT REAR Large Lower Bar Small Lower Bar SAFETY SIGNS ATTENTION: BECOME ALERT! YOUR SAFETY IS INVOLVED! Replace Immediately If
Pg. 9 Upper Bar Channel Support Support Arm Slide Bracket 3. Tongue Assembly Place the Small Spring (#3) into the holder located at the front
Comments to this Manuals