Pg. 1 O P E R A T O R ’ S M A N U A L Set-Up Instructions and Parts Catalog for Models TB-3500A and TB-6000A Trail-Blazer Header Transports
Pg. 10 SET-UP INSTRUCTIONS (continued) 5. Attaching the Adjustable Brackets and Upper Bar Secure the Upper Bar Channel Support to the left side of
Pg. 11 SET-UP INSTRUCTIONS (continued) 7. Installing the Light Kit A. Insert the Main Wiring Harness, end opposite the Flat-Four Connector End, thr
Pg. 12 SET-UP INSTRUCTIONS (continued) 8. Placing the Amber, Red and Orange Reflective Decals Place the reflective decals as shown below.
Pg. 13 PARTS LIST Main Frame and Upper Bar Front Axle Assembly # Part # Description 2 UB-24H 4" x 8" x 24' Upp
Pg. 14 PARTS LIST Tie-Down Bracket and Adjustable Header Mount Adjustable Upper Bar Mount # Part # Descr
Pg. 15 PARTS LIST Rear Axle Assembly (For Units Equipped WITHOUT Rear Brakes) Rear Axle Assembly (For Units Equipped WITH Optional Re
Pg. 16 PARTS LIST Rear Axle Assembly (continued) (For Units Equipped WITH Optional Rear Brakes) Rear Fender Assembly # P
Pg. 17 PARTS LIST Light Kit Assembly (For Transports Equipped WITHOUT Rear Brakes) * NOTE: For Models TB-3500A and TB-6000A equ
Pg. 18 PARTS LIST Light Kit Assembly (For Transports Equipped WITH Optional Rear Brakes) # Part # Description 1 MWH-HS Main Wiring Harness with
Pg. 19 INITIAL OPERATION / MAINTENANCE BE CERTAIN THAT ALL POWER IS SHUT OFF BEFORE SERVICING THE HEADER TRANSPORT Before the header transport is put
Pg. 2 TO THE DEALER: Read manual instructions and safety rules. Make sure all items on the Dealer’s Pre-Delivery and Delivery Check Lists in the Oper
Pg. 20 SERVICE / MAINTENANCE RECORD Date Description Notes
Pg. 3 MODELS TB-3500A and TB-6000A Header Transports Specifications DIMENSIONS (by Upper Bar Length) 32’ 38’ 4
Pg. 4 GENERAL INFORMATION TO THE OWNER: The purpose of this manual is to assist you in operating and maintaining your running gear in a safe manner.
Pg. 5 GENERAL INFORMATION (continued) BOLT TORQUE CHART Always tighten hardware to these values unless a different torque or tightening procedure is
Pg. 6 TABLE OF CONTENTS INTRODUCTION 2 EXPRESS WARRANTY 2 SPECIFICATIONS 3 GENERAL INFORMATION 4 BOLT TORQUE CHART 5 SAFETY RULES 7 SAFETY 7 SAFE
Pg. 7 SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Safety is a primary concern in the design and manufacture of our products.
Pg. 8 DW-108 DW-121 9 SAFETY SIGNS ATTENTION: BECOME ALERT! YOUR SAFETY IS INVOLVED! Replace Immediately If Damaged or Missing! IMPORTANT: Install
Pg. 9 SET-UP INSTRUCTIONS (continued) 3. Mounting the Rear Fenders Place one of the Base Fender Support Rail (left or right) on top of the two rear
Comments to this Manuals